Verify that the banner is configured for login

Defines a customised banner to be displayed before the username and password login prompts. Below example helps in validating Banner configuration using NetYCE Compliance module

Example config

campus01-b02-access01 and campus01-b02-access02 are the two reference devices which we are using for this example. One has banner configuration and other does not.

Below command output gives us the information.

campus01-b02-access01#

campus01-b02-access02#

How its done

Below are the steps to create new policy.

Operate → Compliance → Policies → New→

Click on the Node Group to select the relevant group of devices to add. Node group named “building2_access” holds the nodes of both the nodes:

Rule → New , Rule Type → Configuration , Vendor → Cisco IOS

Report/test results:

Below is how to create reports to see the results of the compliance policies.

Operate → Compliance → Reports → New → Report Name “test” → Report type “Policies” → Policy Name “Sample 2 : Login banner” → Show Report

This was a simple example to understand how to implement compliance policy to verify banner configuration.