LDAP: couldn't connect to LDAP server

Differences

This shows you the differences between two versions of the page.

--- releases:7.0.4_20180612 [2018/06/12 11:16] – created yspeerte
+++ maintenance:releases:7.0.4_20180612 [2019/12/23 15:49] (current) – yspeerte
@@ Line 1: / Line 1: @@
+{{indexmenu_n>20180612}}
+===== NetYCE 7.0.4 Build_20180612 =====
+===== Release notes =====
+Date: 2018-06-12
+\\
+<WRAP widths 60% box safety>
+==== Enhancement ====
+</WRAP>
+=== Template usage ===
+<WRAP indent>
+The 'Template usage' tool from the 'Operate - Node config' menu was updated to support
+selections involving Vendor-types. With the introduction of sub- and port-templates per
+Vendor-type, mutiple templates could have the same name.
+Locating the nodes using such a multivendor template with this tool would properly report
+the nodes referencing it, but it did not permit for distinguishing between the vendors.
+It also could not detect if a multivendor template was missing for a spefic vendor.
+Now an additional selection and filter function for the Vendor-type is added to the tool,
+allowing for tracing templates for specific vendors.
+</WRAP>
+=== 'Cmd_exec' Quick-mode ===
+<WRAP indent>
+For some changes it is desirable or even a must NOT to save the configuration on change completion.
+To facilitate these situations the scenario command 'cmd_exec' has been extended with the '-q'
+option to enavle the 'quick-mode'.
+When setting this -q flag, the NetYCE vendor modules will execute the commands as usual, but will
+skip the configuration save, backup and nccm submission at the start AND at the end of the change.
+</WRAP>
+\\
+<WRAP widths 60% box safety>
+==== Fix ====
+</WRAP>
+=== Redundancy check ===
+<WRAP indent>
+It was noted that during the execution of a scenario where the availablility of the redundant
+switch was tested, an incorrect managment ip-address was used.
+It turned out that the scenario 'reachable' command retrieved the management address of
+a device using a slightly different set of citeria. The various front-end and back-end software
+modules involving management-addresses were reviewed and now all use the same set of criteria.
+</WRAP>