Table of Contents

Command parsing on Cisco IOS finding interfaces and ports

The goal of this example is to find interfaces that belong to specific vlans.

Create a new Command Job and save it using a desired name.

Command Job

The job is “empty”. It still requires something though, so it's filled with a '!'.

!

Parsing template parsevlan

The command that is used is show vlan | i user|data.

This parse template will match specifically on the word “active”. For those lines it will set the vlannumber and vlandescr variables.

<vlannumber> <vlandescr> active |*|

Parsing template intfnumber

The command show int switchport | i Name:|Access Mode VLAN is used to find the combination of information of interface and (data) vlan.

In this parsing template and % sign is used to create a hash to store the other variables in relation to it. This allows to retrieve the <accessvlan> variable using the following inside a loop in the scenario: <<interface>.accessvlan%intf>

Name: <%interface>
Access Mode VLAN: <accessvlan>

Make sure to read the hash article on how <variable> is different than <%variable>.

Job scenario

Description Parsing vlan and interfaces on <node> 
task := scn_parse_vlan_intf

Scenario scn_parse_vlan_intf

# Test whether node is live and reachable
reachable -n <node>
if <error>
    LogAction -n <node> -a Parse_job -m "<node> is not reachable"
    stop
endif
LogAction -n <node> -a Parse_job -m "<node> is reachable"


<%cmd> := parse_cmd -n <node> -t parsevlan -r "show vlan"
<vlans> := keys <%cmd>

foreach <vlan> in <vlans>
    log -m "vlan: <vlan>"
    
    <%intf> := parse_cmd -n <node> -t intfnumber -r "show int switchport \\| i Name:\\|Access Mode VLAN"

    <interfaces> := keys <%intf>
    foreach <interface> in <interfaces>
        log -m "interface: <interface>"
        log -m "vlan: <<interface>.accessvlan%intf>"
        if "<<interface>.accessvlan%intf> == <vlan>"
            log -m "Interface found, generating and/or appending configuration"
            
            config_create -n <node> -t user_interface -f <node>_user_intf.cmd -x
            if <error>
                Logaction -n <node> -m "Failed to create the template for <node>"
                Stop
            endif
            
    endeach
endeach

log -m "Pushing new configuration"
config_exec -n <node> -f <node>_user_intf.cmd
if <error>
    Logaction -n <node> -m "Failed to configure <node> commands"
    Stop
endif

end

Some things to note: